Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Fox Point, WI

Roll-Up Door Repair in Fox Point, WI

Sheet roll-up doors for storage units, sheds and warehouses repaired. Typical cost $150-$600.

Need roll-up door repair in Fox Point, WI? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Sheet roll-up doors for storage units, sheds and warehouses repaired.

Signs you need roll-up door repair

  • The door is hard to lift or won't stay up
  • A dented or creased curtain
  • The latch won't lock
  • The door comes out of its guides

Common causes

  • Loss of spring tension
  • Impact damage
  • Worn latches and stops

What you can check yourself

  • Check whether the stops at the top of the guides are in place.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Inspect the curtain, guides and drum
  2. Adjust or replace the springs
  3. Repair the curtain or replace the door
  4. Replace latches and stops
  5. Test it

Typical roll-up door repair prices

$150-$600Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Roll-Up Door Repair in Fox Point, WI

Road salt and meltwater dripping off vehicles rust the bottom of tracks, cables and roller stems, which is why cable and roller failures in Wisconsin usually start at floor level.

Technicians serve all of Fox Point (ZIP codes 53209 and 53217), plus Bayside (1.6 mi), Glendale (2.3 mi), Whitefish Bay (3.1 mi) and Brown Deer (3.2 mi). Call (833) 435-8883 to book a visit in Fox Point.

Roll-Up Door Repair: frequently asked questions

How much does roll-up door repair cost in Fox Point, WI?

Roll-Up Door Repair typically costs $150-$600 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do roll-up door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is roll-up door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Wisconsin or Fox Point requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Fox Point, WI

Windsor Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Sommer Garage Door Opener Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$350

Allstar Opener Gear & Sprocket Replacement

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$275

Wood Garage Door Repair

Rotted, warped or split wood sections repaired, sealed and rebalanced.

Typical $200-$700

Genie Garage Door Opener Installation

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $350-$800

Martin Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Richards-Wilcox Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Clopay Garage Door Roller Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$350

Richards-Wilcox Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Screw Drive Opener Repair

Screw-drive openers cleaned, lubricated and repaired.

Typical $125-$350

Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Fox Point, WI now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote